1. Take the coated sample to the letterpress, and after the letterpress is pressurized, check whether there is any whitening at the pressure.

2. Take the appropriate area of film coated sample and rub it back and forth with both hands. If it is not taken off or white, the product quality is good.

3. Open and tear the plastic film layer on the coated sample by hand to see if the printing ink layer can be completely attached to the film, or tear the paper base apart.

4. Put the coated sample into the baking chamber and bake at high temperature. The quality is good if there is no demoulding or foaming.

5. After soaking the coated sample in water at room temperature for about 1 hour, the film layer is not separated from the printed paper, which indicates that the film layer is firmly attached.

Hope this small make up to tell you about five buildings film face plywood quality of testing method will be helpful to you, and can better use the interpretation of the content, so as to solve the procurement process often meet the quality question, here we wish you to the choose and buy high quality architectural film face plywood.