Building film face plywood manufacturers in architectural decoration when you need to use the template for stent assisted, after will be to remove, but many people don't care when removed, so caused some unnecessary loss.The staff of this building template manufacturer specially reminds you to pay attention to the following two details when dismantling:

              （Special template for high-rise buildings）

    1. Remove the horizontal bar first and then the vertical bar.When the beam formwork is removed, the side die is removed first, and then the bottom die is removed. When the concrete strength is removed, the surface and edges are not damaged due to the removal of the die.The strength of concrete must meet the requirement when the formwork is removed.

2. The cleaning must be in place, and the coating demoulding agent should be even, and the demoulding time must be carried out in accordance with the notice of the technical room, so as to avoid the occurrence of quality defects such as concrete sticking molds.

In addition, also need to be aware of is dismantled to dismantle the brace and inclined pull rod, removing the level stare blankly back again, with a crowbar and gently move the template, the template away from the concrete, shall not be too hard, especially the Angle of Yin and Yang and the hole template, in order to avoid deformation of the template.